Afterburner Ring 76mm, short, EDF
The short Ultra-Power afterburner rings are based on the same emitter technology and on the specially manufactured aluminium core PCBs, but waive the cooling ducts to save size and weight. They have a lower performance in order to enable normal operation for the model. This is basically implemented by a puposely thin cable. The rings may only be operated permanently about 1 minute and therefore, the mixing to the gas channel should only happen in the upper section. Since a too high ambient temperatures should be avoided, these rings are specially suitable for EDS systems and score with the low weight.
The light output of the emitter rings is gigantic high and even in an area of >120° to all ring sides visible. Thus, it will both directly shine into the outlet and into the nozzle, which strengthens tremendously the effect of a glowing pushing rod.
Direct operation with 2S (8V) Lipo. Please ensure sufficient cooling air during operation. The high power requirement of the afterburner rings requires sufficiently dimensioned batteries and an efficient control. Please see our recommended modules.
This ring is delivered with a 1m/0.25mm silicon cable. A second cable can be soldered in if needed. For a better light distribution, you can use our nozzle attachments under the rubric accessories.
NEW: Each afterburner ring comes with a matching 2nd generation Nozzle attachment. With the cover you get a totally different light effect, especially recommended if the ring can be fully visible during operation.
Performance: 18 emitters with 40-70 Lumen
Electricity: ca. 2.5A
Beam angle: ~100°
Internal Dimension: 76.2mm
External dimension: 90mm
Weight: 14g (without cable)
Delivery: ready to use with 1m connection cable for 2S LiPo operation
With the X2 technique high power LEDs are operated in a "cluster". These achieve double the light output for the same heat or the same light output at half heat dissipation. Yet our X2 lights are still fully compatible with all our other lamps. If X2 lights, such as spotlights, are supplied with separate cables, these cables must be used in the delivered wiring! X2 lights are reacting more strongly on a weakening battery.
The reference power is a comparison value between our offered lights. It normally refers to an operating voltage of 12V/3S Lipo and is dependent on bulbs, operating mode and technology.
Pay always attention to the operating temperature, we do not assume any warranty in case of overheating.
Note: The LED lights are extremely bright! Never look directly into a LED!